Rectorseal WBB300 Outdoor Condenser Wall Bracket, supports up to 300 lbs.

Excellent Product, Fast Shipping

Extremely easy to install, great price, and being mounted to the wall enables the unit to remain clean.

Good quality product.

Easy to mount and very adjustable.

In my opinion, this wall bracket is a "must" for any mini-split installation. It is sturdy, simple, clean, and completely adjustable. A very slick accessory.

It seems to be well built- I needed to mark a hole location on the cross support and used a nail to scratch the paint without any evidence that I had scratched through the finish. Hopefully it is a thick paint which will last a long time. The cross-member is long enough to bridge three studs, just barely, but I think it is designed to only use two studs.

That would be fine if the mounting holes were spaced on some increment of 16". Instead, you can have one pre-drilled hole on a stud and then have to drill your own hole 16" over. Not a big deal since you will be drilling pilot holes for the lag screws if you are mounting to wood. If you are mounting to concrete it should work well.

It seems to be well built- I needed to mark a hole location on the cross support and used a nail to scratch the paint without any evidence that I had scratched through the finish. Hopefully it is a thick paint which will last a long time. The cross-member is long enough to bridge three studs, just barely, but I think it is designed to only use two studs.

That would be fine if the mounting holes were spaced on some increment of 16". Instead, you can have one pre-drilled hole on a stud... more

Trying to save a little money getting the wall hole, mounting plate, line hide, compressor mount, etc. up before calling out my HVAC guy.

Went to mount this against garage (standard 16" center on studs) and realized none of the holes in this bracket are 16" apart!

So unless I want a single hold in a stud --I need to either drill more holes in the mount, or what I'll probably do, go buy a couple pieces of pressure treated 2x4 mount top one to multiple studs then mount this to that and use second 2x4 to even out bottom so compressor can be mounted level.

Big Pain I didn't expect. What was Rector seal thinking not having at least one or two holes on 16" centers. If a couple had been on 24" centers (sometimes used in 2x6 construction) I could have given them a little pass. But nope.

Trying to save a little money getting the wall hole, mounting plate, line hide, compressor mount, etc. up before calling out my HVAC guy.

Went to mount this against garage (standard 16" center on studs) and realized none of the holes in this bracket are 16" apart!

So unless I want a single hold in a stud --I need to either drill more holes in the mount, or what I'll probably do, go buy a couple pieces of pressure treated 2x4 mount top one to multiple studs then mount this to... more

Bought it, got it, had it installed. Very sturdy unit, well made. Extremely satisfied. Recommend using it to keep the compressor off the ground and level.

I used this with a Sanyo 18KHS72 mini split with heat pump. Mounted it on the wall of the house below the sunroom. This item was easy to work with, extremely adjustable and had all the needed parts. In service now for six months and no problems.

Something like this could be built out of Unistrutt or some other material but the convenience and time savings make it well worth the price. It's very flexible and sturdy. I plan to buy another for an upcoming installation.

This is a great support. Well made and easy to install. The product is well designed, very strong and the finish quality is very good. All the necessary parts for any installation are included.